RyanJL
XS400 Member
Hi all,
Looking for some advice regarding best ignition timing for TCI on my particular bike.
I'm converting my XS400 from points to TCI at the moment. The engine is running Mikuni VM32 carbs, pod filters, modified exhausts, and was previously dyno tuned with the points ignition. It ran well, and made good power, but one coil has since started to fail so I'm switching over.
This photo shows how the points were set when dyno tuned - quite a lot of ignition advance from what I can tell.

Here's a closer look.

I've since installed the TCI rotor and pickup following the Haynes manual, with ignition timing perfectly aligned to the LF mark on the alternator rotor as it would be when stock. You can see here how that looks.

Is this the best possible option for timing given what we know above about the best tune for my bike with points ignition? Would you dial in a little bit more advance with the TCI than 'standard' to start with? Or just let the TCI unit do that itself? I'm sure it will run with the timing like this, but if I can make it run better - or not worse than before - that would be great.
Thanks for any and all advice.
Looking for some advice regarding best ignition timing for TCI on my particular bike.
I'm converting my XS400 from points to TCI at the moment. The engine is running Mikuni VM32 carbs, pod filters, modified exhausts, and was previously dyno tuned with the points ignition. It ran well, and made good power, but one coil has since started to fail so I'm switching over.
This photo shows how the points were set when dyno tuned - quite a lot of ignition advance from what I can tell.

Here's a closer look.

I've since installed the TCI rotor and pickup following the Haynes manual, with ignition timing perfectly aligned to the LF mark on the alternator rotor as it would be when stock. You can see here how that looks.

Is this the best possible option for timing given what we know above about the best tune for my bike with points ignition? Would you dial in a little bit more advance with the TCI than 'standard' to start with? Or just let the TCI unit do that itself? I'm sure it will run with the timing like this, but if I can make it run better - or not worse than before - that would be great.
Thanks for any and all advice.